|
|
 |
|
 |
|
 |
|
- 35 watts x 4 (2 ohm) continuous power, 80 x 4 (2 ohm) dynamic power, or 100 watts x 2 (4 ohm) continuous power. CEA-2006 Compliant specifications for true, accurate power ratings.
- 4-channel, dual bridge-mono (2-channel), or dual simultaneous stereo/mono operation provide a variety of configurations and setups: 4-channel for front and rear speakers; 2 speakers and a sub; as 2 subwoofers; or as 2 subs and 4-channels in passive-tri mode.
- 2 ohm stable 4-channel operation.
- High-speed MOSFET switching power supply and high current Bipolar Output Transistors pump maximum voltage and high current to your speakers or subwoofers.
- Double Layer Fiberglass Epoxy Printed Circuit Boards for more rigidity and less shrinkage, with plated through-holes instead of jumpers, for twice the amount of component contact area. Efficient layout packs more circuitry, with tighter component tolerances, into a smaller circuit board for a smaller overall amp footprint.
- 6-Way Smart System Protection (SSP) circuits: Power and Ground-Reversal Protection, Thermal and Short Protection, Current Overdraw and Low Impedance Protection circuits with auto-Standby Mode ensure safety, reliability and durability.
- Anodized extruded brushed-aluminum cover and textured end caps for maximum heat dissipation.
- Cast aluminum textured end caps for optimized heat dissipation and hiding of connectors. Solid aluminum logo and model panel back lit in cobalt blue.
- Selectable 12 dB/octave high or low-pass crossover. Defeatable for full range (flat) operation.
- Switchable 8 dB bass boost at 40Hz for extra bass thump.
- Variable input gain optimizes match with different signal sources (250mv to 7.5V).
- RCA Outputs (front channels only)- for easy daisy chaining of other amplifiers.
- Mounting hardware with rubber isolation grommets and extra fuse included.
- Light Bar/Fan Output- Connect an optional LED light bar or cooling fan for custom installations.
- Multi-Color Status LED gives instant information on amplifier operation.
|
|
 |
|
 |
|
|
|
|
14.4 Volts RMS Not Bridged @ 1kHz - 4 Ohms: 35 watts x 4
- 2 Ohms: 50 watts x 4
14.4 Volts Dyanmic Not Bridged 14.4 Volts RMS Bridged - Signal-to-noise (Referenced to rated power): > 98 dBA
- Input Sensitivity Range: 250 mV to 7.5 Volts
- Input Impedance: > 20k Ohms
- Overall Frequency Response (-3 dB Points): 20-20 KHz
- Effective Damping Factor: >100
- Protection circuitry: 1 x 30 amp fuse, Power and Ground-Reversal Protection, Thermal and Short Protection, Current Overdraw and Low Impedance Protection circuits
- Overall Dimensions (with panels): 2-16/25" H x 12-1/2" W x 10-1/4" D
(6.71cm H x 31.75cm W x 26.04cm D) - Product Weight: 10.00 lbs.
- Total Shipping Weight: 12.00 lbs.
- Subsonic Filter: No
- High Pass Filter frequency: 80 Hz
- High Pass Filter slope: 12 dB/octave
- Low Pass Filter frequency: 80 Hz
- Low Pass Filter slope: 12 dB/octave
- Bass Boost Characteristics: +8 dB @ 40 Hz
|
|
|
|
|
|
|
 |
|
 |
