|
|
 |
|
 |
|
 |
|
- 130 Watts x 2 RMS at 4 Ohms1
- 170 Watts x 2 RMS at 2 Ohms
- 340 Watts x 1 RMS at 4 Ohms
- High Level input with Sensing Power On
- 80 Hz Low-pass filter, 18 dB/oct
- 80 Hz High-pass filter, 12 dB/oct
- 0-10 dB Variable 40Hz Low boost
|
|
 |
|
 |
 |
|
 |
|
- Frequency Response: 5 - 50 kHz (+0/-3 dB)
- Harmonic Distortion: 0.05% (at 1kHz)
- Impedance: 2-8 Ohms Stereo or 4-8 Ohms Mono
- Input Level: 0.3 - 6.0V (RCA input) or 1.2 - 12.0V (High Level Input)
- Low Boost: 0-10dB Variable (at 40Hz)
- Operation: 2/1 channel configuration
- Signal-to-Noise Ratio (dB): 93 dBA
- Tone Control(s): LowPass Filter: 80Hz, 18dB/Oct High Pass Filter: 80Hz, 12dB/Oct
- 280 Watts x 2 max power at 4 Ohms
- 400 Watts x 2 max power at 2 Ohms
- 800 Watts x 1 max power at 4 Ohms
- Audio In: RCA Pin Jacks, High Level Input Connector
- Audio Out: Speaker terminals with screws
- RCA Audio Input(s): Pin Jacks: 0.3 - 6V
- Current Drain: At rated output: 30A (at 4 Ohms) Remote Input: 1 mA
- Input Voltage: 10.5-16V Power Supply Voltage
- Internal Power Supply: OTL Output Transformerless Circuit Pulse Power Supply
- Output Power: Maximum Output: 280 Watts x2 or 800 Watts x1 (at 4 Ohms)
- Power Requirements: 12V DC Car Battery (Negative Ground)
- Rated Output: (20Hz-20kHz, 1% THD+N, 14.4V)1 130 Watts x 2 RMS (4 Ohms) 170 Watts x 2 RMS (2 Ohms) 340 Watts x 1 RMS Mono (4 Ohms)
- Dimensions (Approx) Depth: 10"
- Dimensions (Approx) Height: 2 1/4"
- Dimensions (Approx) Width: 15 1/8"
- Dimensions (Approx.): 15 1/8" x 2 1/4" x 10" (384 x 55 x 252 mm)
- Weight (Approx.): 6 lbs. 10 oz.
- CEA-2006 Compliant — Standardized “Voluntary” Testing & Measurement Methods for Mobile Audio Amplifiers. This standard advocates a uniform method for determining an amplifier’s RMS power and signal-to-noise ratio. Using 14.4 volts, RMS watts are measured into a 4-ohm impedance load at 1 percent Total Harmonic Distortion (THD) plus noise, at a frequency range (for general purpose amplifiers) of 20 Hz to 20,000 Hz.
|
|
 |
|
 |
|
|
 |
|
 |